First of all sorry for the low quality I didn't had the proper tools. Ok let's start now.
Well every one has these holographic projector in movies and envied them, but now you can have your own and its really simple to make one.
Following is the stuff you need to make your own Hologram Projector.
Equipment
- Lead Pencil(Just to draw the outlines)
- Knife (Or what ever do you think is good for cutting plastic if you have hot knife that would make things a lot easier)
- A paper (To draw outlines)
- Some Plastic pieces Or Glass but its hard to cut glass (I used old CD covers you can use any plastic pieces But it should be scratch less as mine had some scratches.)
- A Protractor(To measure the angle of both lines)
Outline
So now let's draw the basic outline on the paper I use angle 120 depending on how big or small you want it be you can change the angle.
Cutting the outline
Now cut out the outline that you have drawn on your paper.
After that place the outline on plastic piece.
After this draw the outline on the plastic piece, it should look something like this.
Plastic Cutting
Here comes the hard part well for me it was now that you have your outline start cutting remember patience is the key here just do it slowly.Well if it does not turn out very good you still have the paper outline that you can use to fix this one.
You can use sand paper to get rid of rough edges.
Now you can use this one as an outline to cut others.
You need 4 of them in total.
Again get rid of the rough edges, now that you have all four of them is good shape you are good to proceed to next step.
There are two ways to do this step you can either use glue or tape.
Here is the video for the final results Hope you enjoy sorry for the low quality once again as my plastic pieces were scratched. And I did not had proper tools.
