lovely wenesday morning my sweet people of jewelry comunity. Hope you all are doing good in your differnt destination and everything is good with you all. Well i have been good and interesting in all i am doing . I thank the Almighty God for grace and victory in all i do.
Today is a beautiful day. I want to share with you all the process of making this bracelates craft putting a square in the middle. At first when my boss did it it was very confusing. But when i started doing my own i was getting it. Though at the start it was very difficult to get the first sqare done because i did some miscalculations. I had to return back and do it again and i was able to get it right. Along the line i made the same mistake again. I had to go back and do it again and that was how i go to the extent of the bracelate wrist. And i will be submitting the assignment tomorrow. All thanks to God.
Materials
. Scissors
. Fishing line
.beading needles.
.bracelates hooks
.purple crystal beads
.gold small beads.
I had to start with the cutting out of the fishing lines amd also try to put the needles on both side. Now my needle has a smaller holes so i had to use my teeth to flat the fishing line adge so that it will enter.
After putting the two needles i had to put one side of the bracelates hooks so that i can get the middle as well as the getting one side of the holder.
Next. I put six gold beads on one side of the fishing line with the help of the needle still on that same side i put one crystal purple beads. I went to the other side of the fishing and put one purple crystal beads inside the fishing line. Then i put another one of the gold bead and i make and intertwin between them. From there i pulled it down to the hook which is the middle of the fishing line.
I started the next one to make a complete of the sqare inside the gold beads. I put one purple crystal beads each on each side of the fishing line. From there i put six gold beads inside the fishing line. Then i put an extra gold beads and make and intertwin between then and then close. I was able to get the first square.
So the second square is going to be a repeatation of the first and second steps.
So i went on to doing the repetition of the first steps to get the second square.
I did more of it to get as much sqare as i can so that i can get the full length of the bracelates.
So the last but not the least was to put the last hooks and then wear it to snap and check my work. Guys my assignment is ready and i am so happy to drop the process here.
Thanks for your time and happy morning .