Thank you !
I had a quick look yesterday on the Kindle edition. Nice job !
Few comments:
- For heatbed temperatures, it will be nice to have a table instead of a list.
I like the sections where you describe the different settings for different materials. May be I missed it, but it will be nice to have the settings inside a table after/before the descriptions you put for each of them. - For the initial layer, I think a section for the initial layer speed and the initial layer temperature (+ extrusion flow) would be useful.
- Burn out connectors or wires: may be add some informations about wire gauges and number of amps to be safe, add a short paragraph of the possibility of using an external mosfet or external DC SSR (or AC SSR)
- Extruder Stepper Skipping : there is also the case of the over extrusion (generating also clogs at retractions and/or heat creep)
- Ghosting: it is possible also to setup acceleration/jerk inside the startup gcode without re-flashing the board
- Heater malfunctioning: probable typo 12V 30A instead of 12V 30W
RE: FREE Download - 3D Printing Failures 2019 Edition